Simplicity is what you can call the life of garage doors. Its entire life is spent going up and down, day in day out. But this simple function is not always guaranteed, unfortunately.
You purchased and installed a garage door with longevity in mind. Over time, garage doors succumb to wear and tear, and replacement may be necessary. Even the most reliable or durable will someday bite the dust. But you can push this inevitability further.
There are a handful of routine tasks you can perform to push your garage’s usable life further and minimize the cost of repair.
Photo-Eyes
One of the most critical maintenance tasks is to ensure photo-eyes or the infrared sensors stay in alignment. Any misalignment can keep Austin’s Greater Garage Doors from closing correctly, allowing access to animals and other intruders. Keep checking the photo-eyes alignment and confirm they are doing the work they should.
Are the sensors detecting any obstructions? Is the garage door operating correctly, and is it safe?
Secure the Hardware
The garage door tracks are usually in brackets and assembled in sections. The up and down tension can sometimes loosen the bolts holding the brackets in place. Check the screws and bolts and tighten them if necessary.
Test the Reversing Mechanism
Ensuring your garage door works as it should after the Pflugerville garage door installation is both a maintenance and safety task. A properly working garage door is safe and reduces any risk of accidents. But how do you ensure the garage is working properly?
By regularly testing the reverse mechanism. Place an obstruction such as a wooden board on the garage door’s path and see if it reverses. If it does not, it’s time to ring a professional garage door handyman. It needs some tweaking.
Clean the Rollers and Tracks
The rollers and tracks of your garage door deserve some TLC to keep them in good working condition. Brush off any debris and lubricate the axles and rollers. Keep an eye on the bearings and replace them if you notice some wear or if it’s not operating smoothly. The bearings on rollers bear the brunt of the friction and are more prone to wear than other components.
Inspect the Rollers, Cable, Springs, and Pulleys
The rollers, cables, springs, and pulleys are prone to quick wear and tear. Your task is to visually inspect for signs of wear and tear, such as frayed cables. Test the garage door’s balance and determine if there are any changes to the pressure needed to move it up and down.
Worn out springs put a lot of pressure on the garage door opener, and it has to work extra hard. This quickly wears out the motor, as well. But don’t attempt to repair or adjust anything.
These components are under high tension and are a safety hazard when mishandled. If you suspect a problem or see visible signs of wear and tear, call a qualified garage door professional to handle it.